Monitoring volcanic hazard using eddy covariance at Solfatara volcano, Naples, Italy

An eddy covariance (EC) station was deployed at Solfatara crater, Italy, June 8–25, 2001 to assess if EC could reliably monitor CO₂ fluxes continuously at this site. Deployment at six different locations within the crater allowed areas of focused gas venting to be variably included in the measured flux. Turbulent (EC) fluxes calculated in 30-min averages varied between 950 and 4460 g CO₂ m⁻² d⁻¹; the highest measurements were made downwind of degassing pools. Comparing turbulent fluxes with chamber measurements of surface fluxes using footprint models in diffuse degassing regions yielded an average difference of 0% (±4%), indicating that EC measurements are representative of surface fluxes at this volcanic site. Similar comparisons made downwind of degassing pools yielded emission rates from 12 to 27 t CO₂ d⁻¹ for these features. Reliable EC measurements (i.e. measurements with sufficient and stationary turbulence) were obtained primarily during daytime hours (08:00 and 20:00 local time) when the wind speed exceeded 2 m s⁻¹. Daily average EC fluxes varied by ±50% and variations were likely correlated to changes in atmospheric pressure. Variations in CO₂ emissions due to volcanic processes at depth would have to be on the same order of magnitude as the measured diurnal variability in order to be useful in predicting volcanic hazard. First-order models of magma emplacement suggest that emissions could exceed this rate for reasonable assumptions of magma movement. EC therefore provides a useful method of monitoring volcanic hazard at Solfatara. Further, EC can monitor significantly larger areas than can be monitored by previous methods.     

Impact of precipitation seasonality changes on isotopic signals in polar ice cores: a multi-model analysis

For Central Greenland, water isotope analysis indicates a temperature difference of about 10°C since the Last Glacial Maximum (LGM). However, borehole thermometry and gas diffusion thermometry indicate that LGM surface temperatures were about 20°C colder than today. Two general circulation model studies have shown that changes in the seasonal precipitation timing in Central Greenland might have caused a warm bias in the LGM water isotope proxy temperatures, and that this bias could explain the difference in the estimated paleotemperatures. Here we present an analysis of a number of atmospheric general circulation model simulations mostly done within the framework of the Paleoclimate Modeling Intercomparison Project. The models suggest that the seasonal cycle of precipitation and surface mass balance over Central Greenland at the LGM might have been very different from today. This supports the idea that the accuracy of the water isotope thermometry at the LGM in Greenland might be compromised as a result of a modified surface mass balance seasonality. However, the models disagree on the amplitude and sign of the bias. For Central East Antarctica, a strong seasonality effect on the LGM isotopic signal is not simulated by any of the analyzed models. For the mid-Holocene (6 kyr BP) the models suggest relatively weak isotope paleothermometry biases linked to changes in the surface mass balance seasonality over both ice sheets.     

Petrology and Geochemistry of the Volcanic Rocks Dredged from the Geophysicist Seamount in the Kurile Basin: Evidence for the Existence of Thinned Continental Crust

Dredged samples from the Geophysicist seamount volcano in the northeastern part of the Kurile Basin include volcanic and volcanoclastic rocks ranging from basalt to andesite. The rocks have geochemical features typical of high-K island-arc calc-alkaline volcanism. They are enriched in LILE and depleted in Zr, Ti, Nb, Ta and Y. The chondrite-normalized REE patterns are characterized by enrichment of LREE similar to those of island-arc lava from the submarine volcanoes of rear-arc zone of the Kurile Island Arc. The volcanic rocks have a wide range of ⁸⁷Sr/⁸⁶Sr ratios (0.70287-0.70652), varying ¹⁴³Nd/¹⁴⁴Nd and Pb isotopic ratios. Their trace-element compositions and Sr-Nd-Pb isotope signatures may be explained by a small addition of crustal continental component to mantle-derived magmas that suggest the existence of thinned continental basement under the eastern part of the Kurile Basin.     

A Mid Cretaceous origin for the Galápagos hotspot: volcanological, petrological and geochemical evidence from Costa Rican oceanic crustal segments

The Quepos, Nicoya and Herradura oceanic igneous terranes in Costa Rica are conspicuous features of a Mid to Late Cretaceous regional magmatic event that encompasses similar terranes in Central America, Colombia, Ecuador and the Caribbean. The Quepos terrane (66?Ma), which consists of ol-cpx phyric, tholeiitic pillow lavas overlain by highly vesicular hyaloclastites, breccias and conglomerates, is interpreted as an uplifted seamount/ocean island complex. The Nicoya (～90?Ma) and Herradura terranes consist of fault-bounded sequences of sediments, tholeiitic volcanics (pillow lavas and massive sheet flows) and plutonic rocks. The volcanic rocks were emplaced at relatively high eruption rates in moderate to deep water, possibly forming part of an oceanic plateau. Major and trace element data from Nicoya/Herradura tholeiites indicate higher melting temperatures than inferred for normal mid-ocean-ridge basalts (MORB) and/or a different source composition. Sr–Nd–Pb isotopic ratios from all three terranes are distinct from MORB but resemble those from the Galápagos hotspot. The volcanological, petrological and geochemical data from Costa Rican volcanic terranes, combined with published age data, paleomagnetic results and plate tectonic reconstructions of this region, provide strong evidence for a Mid Cretaceous (～90Ma) age for the Galápagos hotspot, making it one of the oldest known, active hotspots on Earth. Our results also support an origin of the Caribbean Plate through melting of the head of the Galápagos starting plume.     

Dissolution rates and activation energy for dissolution of brucite (001) : A new method based on the microtopography of crystal surfaces

Scanning Force Microscopy (SFM) was used to develop a method which can provide quantitative kinetic data of crystal growth and dissolution. Based on observations of single crystal faces in monolayer resolution, morphology and temperature dependent growth and dissolution rates can be obtained. From these kinetic data activation energies can be calculated and compared with existing theories. The experimental method works by extracting grown or dissolved terrace areas and step densities from image sequences taken at different temperatures. As an example, the method is applied for dissolution on the brucite (001) surface in acidic water (pH 2.7) within the temperature range of 21 to 35°C. At these conditions the dissolution rate depends nonlinearly on the step density and gives evidence for interstep interaction. The calculated activation energy for dissolution is 60 ± 12 kJ mol⁻¹. With this high activation energy, dissolution cannot be regarded as a transport-controlled process, and is therefore surface controlled.     

The magmatic to hydrothermal transition and its bearing on ore-forming systems

The exsolution of volatile phases from silicate magmas controls physical and chemical magma properties and influences large-scale geologic phenomena and processes having major societal and economic implications including the release of climate-altering gases to the atmosphere, the explosivity of volcanic eruptions, hydrothermal alteration, and the generation of magmatic–hydrothermal mineralization. These volatile phases exsolve from a wide variety of magmas and cover a very broad spectrum of compositions.

The transition from the orthomagmatic to the hydrothermal stages has important bearing on these fundamentally important geologic phenomena, and this report summarizes the published results of a dozen scientific investigations on the magmatic–hydrothermal transition as applied to volcanic eruption and magmatic–hydrothermal mineralization. These studies involve a variety of analytical and experimental methodologies, and many focus on fluid and melt inclusions from mineralized magmatic systems. A primary goal of each study is to better understand the role of magmatic volatiles and the importance of the magmatic–hydrothermal transition on these geologic processes.     

Magma evolution and the formation of porphyry Cu–Au ore fluids: evidence from silicate and sulfide melt inclusions

Silicate and sulfide melt inclusions from the andesitic Farallón Negro Volcanic Complex in NW Argentina were analyzed by laser ablation ICPMS to track the behavior of Cu and Au during magma evolution, and to identify the processes in the source of fluids responsible for porphyry-Cu-Au mineralization at the 600 Mt Bajo de la Alumbrera deposit. The combination of silicate and sulfide melt inclusion data with previously published geological and geochemical information indicates that the source of ore metals and water was a mantle-derived mafic magma that contained approximately 6 wt.% H₂O and 200 ppm Cu. This magma and a rhyodacitic magma mixed in an upper-crustal magma chamber, feeding the volcanic systems and associated subvolcanic intrusions over 2.6 million years. Generation of the ore fluid from this magma occurred towards the end of this protracted evolution and probably involved six important steps: (1) Generation of a sulfide melt upon magma mixing in some parts of the magma chamber. (2) Partitioning of Cu and Au into the sulfide melt (enrichment factor of 10,000 for Cu) leading to Cu and Au concentrations of several wt.% or ppm, respectively. (3) A change in the tectonic regime from local extension to compression at the end of protracted volcanism. (4) Intrusion of a dacitic magma stock from the upper part of the layered magma chamber. (5) Volatile exsolution and resorption of the sulfide melt from the lower and more mafic parts of the magma chamber, generating a fluid with a Cu/Au ratio equal to that of the precursor sulfide. (6) Focused fluid transport and precipitation of the two metals in the porphyry, yielding an ore body containing Au and Cu in the proportions dictated by the magmatic fluid source. The Cu/S ratio in the sulfide melt inclusions requires that approximately 4,000 ppm sulfur is extracted from the andesitic magma upon mixing. This exceeds the solubility of sulfide or sulfate in either of the silicate melts and implies an additional source for S. The extra sulfur could be added in the form of anhydrite phenocrysts present in the rhyodacitic magma. It appears, thus, that unusually sulfur-rich, not Cu-rich magmas are the key to the formation of porphyry-type ore deposits. Our observations imply that dacitic intrusions hosting the porphyry–Cu–Au mineralization are not representative of the magma from which the ore-fluid exsolved. The source of the ore fluid is the underlying more mafic magma, and unaltered andesitic dikes emplaced immediately after ore formation are more likely to represent the magma from which the fluids were generated. At Alumbrera, these andesitic dikes carry relicts of the sulfide melt as inclusions in amphibole. Sulfide inclusions in similar dykes of other, less explored magmatic complexes may be used to predict the Au/Cu ratio of potential ore-forming fluids and the expected metal ratio in any undiscovered porphyry deposit.Editorial handling: B. Lehmann     

Luminescence dating of ice‐marginal deposits in northern Germany: evidence for repeated glaciations during the Middle Pleistocene (MIS 12 to MIS 6)

The exact number, extent and chronology of the Middle Pleistocene Elsterian and Saalian glaciations in northern Central Europe are still controversial. This study presents new luminescence data from Middle Pleistocene ice‐marginal deposits in northern Germany, giving evidence for repeated glaciations during the Middle Pleistocene (MIS 12 to MIS 6). The study area is located in the Leine valley south of the North German Lowlands. The data set includes digital elevation models, high‐resolution shear wave seismic profiles, outcrop and borehole data integrated into a 3D subsurface model to reconstruct the bedrock relief surface. For numerical age determination, we performed luminescence dating on 12 ice‐marginal and two fluvial samples. Luminescence ages of ice‐marginal deposits point to at least two ice advances during MIS 12 and MIS 10 with ages ranging from 461±34 to 421±25 ka and from 376±27 to 337±21 ka. The bedrock relief model and different generations of striations indicate that the older ice advance came from the north and the younger one from the northeast. During rapid ice‐margin retreat, subglacial overdeepenings were filled with glaciolacustrine deposits, partly rich in re‐worked Tertiary lignite and amber. During MIS 8 and MIS 6, the study area may have been affected by two ice advances. Luminescence ages of glaciolacustrine delta deposits point to a deposition during MIS 8 or early MIS 6, and late MIS 6 (250±20 to 161±10 ka). The maximum extent of both the Elsterian (MIS 12 and MIS 10) and Saalian glaciations (MIS 8? and MIS 6) approximately reached the same position in the Leine valley and was probably controlled by the formation of deep proglacial lakes in front of the ice sheets, preventing a further southward advance.     

Scientific problems addressed by the Spektr-UV space project (world space Observatory—Ultraviolet)

The article presents a review of scientific problems and methods of ultraviolet astronomy, focusing on perspective scientific problems (directions) whose solution requires UV space observatories. These include reionization and the history of star formation in the Universe, searches for dark baryonic matter, physical and chemical processes in the interstellar medium and protoplanetary disks, the physics of accretion and outflows in astrophysical objects, from Active Galactic Nuclei to close binary stars, stellar activity (for both low-mass and high-mass stars), and processes occurring in the atmospheres of both planets in the solar system and exoplanets. Technological progress in UV astronomy achieved in recent years is also considered. The well advanced, international, Russian-led Spektr-UV (World Space Observatory—Ultraviolet) project is described in more detail. This project is directed at creating a major space observatory operational in the ultraviolet (115–310 nm). This observatory will provide an effective, and possibly the only, powerful means of observing in this spectral range over the next ten years, and will be an powerful tool for resolving many topical scientific problems.